Can anybody mining with 290 (non-x) Tri-x share their 4ch rate ?
I get only 17xxxx which is similar to reference 290 card !
Tri-x should produce more, I have read someone is getting over 2xxxxx
I run with stock rate (no OC) i.e. Core 1000 & Memory 1300
Can someone mention better core/memory combination to reach above 200k 4ch ?
core 1025 or 1000, mem 1500
on a 7950 i get 119,353 currently with 1100/1500
make sure you're setting the miner at 4 cores and higher cpu usage
Thanks for the reply, but 7950 is different from 290 Tri-x
I don't think we need to increase memory for it, rather I get better result by decreasing it upto 1000 for scrypt or heavycoin mining.
Yes, core could be increased for sure. I was getting optimum result for heavycoin mining with 1100 core & 1000 memory but
when I use the same setting for this miner, it crashes after 15-30 min.
I am using
-Motherboard : Intel DZ87KLT-75K
-Processor : Intel Core i5 4660
-PSU : Cooler Master Silent Pro 1200 Gold
-RAM : Corsair Vengeance 8GB (Single Stick)
-3x GPU : Sapphire 290 Tri-x OC edition (2 directly attached to MB & 1 on USB powered riser)
Please post your 4ch result & core/memory setting to obtain that.
As I said earlier I get only 177k with stock rate (1000/1300) & not at all satisfied with it.
BTW with the above 3 cards my Processor is using 30-35% of the resources.
I think it crashes because you have two cards on board and when you overclock them, they overheat or something.
I know that you stated in the read me that older cards are not supported, but it would be a niche if you can update the miner to be able to use HD6xxx/HD5xxx series cards. Other miners lack that and it would be an interesting challenge too, plus an advantage.
It would be a waste of time. These card dont break even anymore. Better work on cards that really earn something.