Hi, I have 2 chilis - one from Marto and one that is either from Lucko or MrTeal (I'm not complety sure-it is a dark green pcb with "The Chili Rev 2.1" written on the the upper left side). I flashed the Marto's board with the 1.0v firmware. It went super - everything works way better. But then I flashed the other board - 2-3 sec. after the power cycle the LEDs 5,6,7,8 stay constantly on, 1 and 3 blink synchronously with rate about 2 times in 1 second, LED 2,4 stay off. What should I do? The board worked 3 months wihout any problems. But now it is like dead, windows doesn't find it.
P.S. After a whole day of testing (multiple restarts and waiting together with some heating through a hair dryer) the unit started, the leds went off and windows found the device. Aftert a short moment of joy I discovered that only 4 engines are working - the others are missing. I reflashed again with the same 1.0v FW - but again - the same happened. Next time I have the unit working Im gonna return to the previous fw.
P.S.2 Well. After another day of testing I realised that I can not return the previous FW. I'm stuck with 4 engines now.
Does the board have a rectangular white sticker on it that says something like
AMSXXXX
WO#DMXXXX-XXXX
REV:2.1
If so, it's one of ours. If not, it's one of the ones made by Lucko. I would say it's likely that it's likely that it is one of the Lucko boards if you needed to take a hairdryer to it.
Can you describe what you mean by you can't return to the previous FW? Does the flashing not work?