Ninjastic
PostEdited versionsQuotes to this post
Post
Topic
Board Hardware
Re: [Guide] Dogie's Comprehensive Bitmain AntMiner S2 Setup [HD]
by
Wookie50
on 29/04/2014, 16:03:24 UTC
Quote from: dogie on April 28, 2014, 07:02:13 AM
Quote from: Kuma on April 28, 2014, 06:16:20 AM
Quote from: Wookie50 on April 28, 2014, 06:06:26 AM
Guys -- a noob question: 

I have a Corsair 1200i that I'd like to replace the S2's Enermax PSU.  However the pinouts aren't compatible ... can't plug in the motherboard plugs from the S2 into the modular connection of the 1200i.  Is there an adapter I need to use?

Thanks!
You need to use cables from your Corsair 1200i. I'm guessing you just disconnected cables right from the PSU, am I right?
This. Remove all the power cables that were in the S2 and start again.

Thanks for the suggestion!  I was hoping to just disconnect the S2 cables from the Enermax and plug them into the Corsair.  No go on that -- S2 cables don't fit into the Corsair plugs.  Bummer.

Based on your suggestion, I'm assuming that the Corsair cables will plug into the S2 -- haven't tried it yet but will do so and report back.  Need to take all the modules out of the S2 again to pull this off since the cables do go under the modules.