Hi everyone.

First off, thank you all for your hard work on this project. I was trying to flash this custom AxeOS firmware onto the LV08 and have been having trouble. I have tried with both Adafruit ESPTool website and with bitaxetool via Python to flash the new firmware. I am running a Windows computer using a CP2104 serial converter USB 2.0 to TTL UART 6PIN module serial converter board module. From what I can tell it is flashing the firmware onto the ESP32 because it passes the hash check at the end and then asks me to reset the device. I have attempted to use  esp-miner-factory-lv08-v2.6.0-1.0.3.bin ;  esp-miner-factory-lv08-v2.8.1-1.5.0.bin ;  esp-miner-factory-lv08-v2.9.0b1-1.5.0.bin  ; lv08-factory-firmware-1.0.0.bin  and none of them get the device to work properly. The miner itself runs the fans at full speed when I power it up and the screen never displays any information. I have also tried to flash the config-lv08.cvs file at the same time as the main firmware (again with both methods of flashing) and this does not make a difference. Here is an image of what I believe is a successful firmware flash via bitaxetool: https://ibb.co/j96rgw45   Even when trying to go back to the stock Lucky Miner firmware I cannot get my device to work at all. I do not see the miner creating a Wifi network for me to connect to either which I figured is not a reassuring sign. I do not see any obvious signs of physical damage that I have caused while attempting this. Does anyone have any ideas what I can do to fix this or at least get back to the stock firmware?

Thanks in advance!