I have modded two complete blade units so far, I found rotating the whole blades orientation gives less hardware errors over the long term, allowing for better heat dissipation, I just fitted sticky pads to the metal heat sink, so you have the foam sheets out to the side rather than on the top or bottom.

I fitted the following a 35v 220uf capacitor, 43k ohm resistor 0.1 +/-, 2 Northbridge heat sinks and fans attached on the rear of each power board, passive heatsinks on the FETs and choke.

Running very stable at 1013mhz, with virtually no hardware errors at all.