LOCAL/REMOTE MASTERNODE SETUP WITH COLD WALLET UNDER THE LAST UPDATE

I would like to report that I was able to update and run my masternodes, using the local/remote wallet setup. The process was the same, but you need to remember that the local wallet is also going to need its own masternodeprivkey=[output from genkey]. So once you have the server side ready. On your local wallet darkcoin.conf change masternode=1, to 0. Get the masternode privkey, add it to the darkcoin.conf and change back to masternode=1. After that, follow the same process we used before to start the masternode remotely. From humanitee:

Start darkcoind on the remote machine.
On your local machine, send 1000 DRK to a newly generated wallet. Send it to the 0th address. If you use darkcoin-qt version to make your wallets, send it to the first (and only if it was newly generated) address.
On your local machine specify the server IP at launch with:
./darkcoind -masternodeaddr=YOUR_SERVER_IP:9999
Unlock your local machine's newly generated 1000 DRK wallet with your passphrase, ## is the time in seconds before the wallet will be once again locked:

 ./darkcoind walletpassphrase 'your wallet passphrase here' ##

On your local machine,

./darkcoind masternode start

For the above to work your local wallet must already have its own privkey on the darkcoin.conf (this key is different from the server one). I hope this helps.