Hmmm. I could potentially have 100 minion chips with their compensation offer which, if built into miners, would offer up a much better chance at ROI than the Prosperos themselves. I would have to start mining by July to make ROI though, so perhaps this is not feasible. Still, having no ROI on 14 TH/s worth of equipment is better than having no ROI on 6 TH/s if I'm looking at an investment within the same range. Is it reasonable to think you guys might have a working set of instructions available for Minions by August? I calculate that my ROI (or lack there of) would be equivalent or marginally better with the chips if I started mining by then.
Correct you can't wait a day into July even if you want to make something of this. I have a few friends in this boat with you and there really is little you can opt for. Sell the chips? Sell the lower level compensation type miners? Get a refund? All I am sure is the WPC really at this point is focused on the form factor and the spoondoolies chips. We want to get something testing in Hong Kong come June at Allied Control. Given where we are now I am not even sure we can make that self imposed deadline but we will know more by May 31st at our meeting.
I would wait for them to get you a miner in your hands. Even if you have a design in hand, parts, fab, etc and a good EE to oversee things I am not sure chips are good option if the trend in getting things to work holds fast you need to have spondoolies / bitmain like commitment to pull off a working board. Also slight errors in fab could render all your chips POOCHED. You can't easily remove this type of chip and start again it would cost you a lot just to try with no certainty of success. I wish you luck and everyone else as well. It is sad to see BA go through such a hiccup so close to the finish line. As for August and a Minion Whiteface or Hornet who knows where we will be given the small team and the tight budget you are probably much better off looking towards someone like Marto, warts and all, for something along that angle to get chips to boards but do your research first before going that route.