Post
Topic
Board Service Announcements
Re: GAWMiners.com - NEXT GEN ASIC
by
rawtashk
on 29/05/2014, 17:38:19 UTC

While wireless devices are not supported in the launch release, we may be including support in a future release. In the meantime, for those of you who require wireless, you can always use an inexpensive wireless bridge device like the one found here -> http://www.amazon.com/Cisco-Linksys-WET11-Wireless-Ethernet-Bridge/dp/B000066JQU


Forgive me if I'm sounding ticked off, but learning the above plus seeing my shipment bounce all over the western US instead of coming fairly direct to me have combined to put me in a pretty foul mood atm.  So....

Uhhh...  that site says "2 new from $100" and, frankly, $100 isn't "inexpensive" in my books.  As well, if I want to go that route I now have to order another part and wait for it to come!  I sure wish I'd known about this before!

So, correct me if I'm wrong...  since it appears I can't use zenminer unless I either string network cable or buy an (cough!) "inexpensive" bridge can I buy a cheap memory card, install the raspberry pi o/s and the GAW cgminer software and run the furys via wifi that way???

Thanks for your help...

Regards,

Chris


Drive out to Best Buy (or Walmart) and get a Netgear one.  Best Buy price matches Amazon, so you can get the amazon price and not have to wait for shipping.  I use one for my mining rigs, and I'll probably be putting this one down there with them as well.