Of course I'm having no luck. I was hoping with the Zencontroller and everyone else's feedback so far that this would be relatively plug & play. The Zencontroller appears to do nothing for me. I registered, tried a couple of pools but it never did anything. The speed registered 0mh/s on zenminer.com and no workers connected poolside.
I tried connecting it to my Linux box, but the device just keeps connecting & then disconnecting 30 seconds later:
May 30 19:13:42 matt-desktop kernel: [122819.321497] cp210x 1-1.1.1.7.1:1.0: cp210x converter detected
May 30 19:13:42 matt-desktop kernel: [122819.397187] usb 1-1.1.1.7.1: reset full-speed USB device number 35 using ehci_hcd
May 30 19:13:42 matt-desktop kernel: [122819.490353] usb 1-1.1.1.7.1: cp210x converter now attached to ttyUSB0
May 30 19:14:12 matt-desktop kernel: [122848.902216] cp210x ttyUSB0: cp210x converter now disconnected from ttyUSB0
May 30 19:14:12 matt-desktop kernel: [122848.902222] cp210x 1-1.1.1.7.1:1.0: device disconnected
Not sure if it will help, but here are the boot messages my Gentoo based linux kernel on my Pi is generating:
[ 10.545771] usbcore: registered new interface driver usbserial
[ 10.545908] usbcore: registered new interface driver usbserial_generic
[ 10.546071] usbserial: USB Serial support registered for generic
[ 10.561381] usbcore: registered new interface driver cp210x
[ 10.561515] usbserial: USB Serial support registered for cp210x
[ 10.561671] cp210x 1-1.3:1.0: cp210x converter detected
[ 10.660020] usb 1-1.3: reset full-speed USB device number 5 using dwc_otg
[ 10.763275] usb 1-1.3: cp210x converter now attached to ttyUSB0
Cassey
http://gawforum.usertalk.info