You might consider adding a ferrite core on the supply wires if you opt with using resistors on the board. Just bridging with solder could add a considerable amount of inductance, and causing EM noise problems down the road, and I believe that to be a bad idea. This may not present as a failed blade, and may instead just limit your ability to ramp up the proc frequency because of HW errors due to unstable supply.
Not to disagree at all, though familiar with ferrite cores had not even heard of ferrite beads before modifying the 5 chip miners, but will just point out that some of the later blades did ship with 0 ohm resistors in place of the anal beads.