So, i just got my G-Blade from MinerEU and i think something is not right after running it for 12 hours 
I'm using the Hashra controller and the clockspeed of 839 (supposed it's the "magic" number) and my top speed is just 4.6Mh/s and the average is 4.4. Also i'm getting to many HW errors. I think 2242 HW errors is way to many for something that it's stock ant not overclocked
Is there any Pi controller i can use that can check the chips individually to see if they are working or the temperature? I'm think i have one or two bad chips on my blades. I was expecting at least 5.5 top and 5.2 average
I'm using the Hashra controller and the clockspeed of 839 (supposed it's the "magic" number) and my top speed is just 4.6Mh/s and the average is 4.4. Also i'm getting to many HW errors. I think 2242 HW errors is way to many for something that it's stock ant not overclocked
Is there any Pi controller i can use that can check the chips individually to see if they are working or the temperature? I'm think i have one or two bad chips on my blades. I was expecting at least 5.5 top and 5.2 average
Maybe you should try the CPU miner for Gridseed from sandor111, I always had the best results with that.
https://github.com/siklon/cpuminer-gc3355
You should get something like 5.6Mh/s with it. HW errors should be only a few.
It also shows the results from each chip, so you can easily track if there are chips doing nothing at all.