Ninjastic
PostEdited versionsQuotes to this post
Post
Topic
Board Hardware
Re: [ANN] Spondoolies-Tech - Best W/GH/s ratio, Best $/GH/s ratio
by
Tsengar
on 17/06/2014, 05:33:58 UTC
Quote from: Spondoolies-Tech on June 17, 2014, 04:53:47 AM
Quote from: Tsengar on June 17, 2014, 04:38:47 AM
Quote from: Bicknellski on June 16, 2014, 05:38:18 PM
Quote from: Spondoolies-Tech on June 16, 2014, 05:23:22 PM
Allied Control (DataTank) experimenting with SP10 immersion cooling:

clip1
pic1
pic2
pic3

Good luck in the upcoming Havelock IPO Smiley

Disclaimer:
We don't endorse the IPO. Each investor should do his/her ROI calculation and decide whether to invest or not.


That is interesting video right there...

Those chips don't seem to get the Novec vapourizing much. Speaks well to the SP10 as an air cooled unit. SP30 board be keen to see that.


Quick introduction, since this will be my fist post here. I am a work colleague of antirack, and I am the one that have been doing the setups for this "lab" tests.

I have been running the SP10 for quite a while now, it works great, just not very optimal circumstances for the boards as they had to be placed horizontal and heat dissipation side down. Hence also a bit tricky to get a good recording of the action, if you so will.

Short explanation: Unlike AM Gen3, we designed the our 1st gen ASIC (Hammer) to dissipate the heat downward, which is far better for QFN package, in our opinion.

I am pretty sure same goes for the BE200 ASIC, but I leave that up to you engineer guys. My comment was of course not meant be negative in any way, just explaining the situation of this tests. I also intentionally kept the ASCI side up to make it look more interesting then a big copper plate. Hopefully soon I can show some boiling action of both sides in a better way.