MY MULTIMINER v3.2.2 SETUP WITH GRIDSEED G-BLADE 5.2MH/S Litecoin mining setup.

(Foreword for the N00bies like me)
"The G-blades show up as STM32 Virtual COM Port by STMicroelectronics" if you have your drivers all setup properly in Windows 7.

I have a problem which you will see from the image below with Litecoin mining (I don't do dual mining mode on these two G-blades):




So it says that I'm getting approximately 11.38MH/s with this config setup.  See the "Arguments" & "Hardware Scan:" contents.

The Wemineltc pool reports that it's only seeing about 6-7MH/s after about 15min.  I've tried another pool & I get the same results.

Also, why does Multiminer alternate & constantly show's only 3 out of the 4 G-blade blades hashing & under the "effective" tab even if all for are connected to the pool only 3 out of the 4 show they're hashing?

I've replicated this on both my laptop & my PC.
I get the same thing happening on both & mentality restarting MiMi (that's my new pet name for Multiminer)  & it never recovers.

I've ruled my USB 2.0 hub out because I swapped it out with another powered USB 2.0 10 port Rosewill hub around twice with the same results.  
Using Windows 7 SP1 OS.

Help?