Ninjastic
PostEdited versionsQuotes to this post
Post
Topic
Board Hardware
Re: The Habanero - 650GH/s - Batch 2 Shipping June 9th, $850 ($1.3/GH/s)
by
MrTeal
on 24/06/2014, 19:10:22 UTC
Quote from: jerbin on June 24, 2014, 05:29:06 PM
Quote from: achtung082 on June 24, 2014, 11:53:50 AM
Quote from: GenTarkin on June 24, 2014, 06:33:43 AM
Quote from: jerbin on June 24, 2014, 06:23:03 AM
Not sure what I am missing, but what screw are you using to attach the Nepton 280L cooling head to the board, nothing seems to fit.
I had to go to home depot and get 8x 3/4" 6-32(think thats what they are, well normal coarse thread PC) screws

Same here. I actually prefer this method to the thumbscrews, have more control and easier to make small adjustments.
http://i.imgur.com/R8Sytcj.jpg


Thanks.. Got it sorted Smiley


Anyone know what is this error?

 [2014-06-25 00:22:11] Hotplug: Hashfast added HFA 50
 [2014-06-25 00:22:12] HFA 50 HFUSBInit usb write err:(-7) LIBUSB_ERROR_TIMEOUT
 [2014-06-25 00:22:12] HFA 50 attempted reset got err:(0) LIBUSB_SUCCESS
 [2014-06-25 00:22:12] HFA : send_packet: OP_USB_INIT USB Send error, ret 0 amount 0 vs. length 8
 [2014-06-25 00:22:17] HFA 0: No response to name query - failed init or firmware upgrade required.
 [2014-06-25 00:22:17] Hotplug: Hashfast added HFA 51
 [2014-06-25 00:22:18] HFA 51 HFUSBInit usb write err:(-7) LIBUSB_ERROR_TIMEOUT
 [2014-06-25 00:22:18] HFA 51 attempted reset got err:(0) LIBUSB_SUCCESS
 [2014-06-25 00:22:18] HFA : send_packet: OP_USB_INIT USB Send error, ret 0 amount 0 vs. length 8
 [2014-06-25 00:22:23] HFA 0: No response to name query - failed init or firmware upgrade required.
 [2014-06-25 00:22:23] Hotplug: Hashfast added HFA 52
 [2014-06-25 00:22:24] HFA 52 HFUSBInit usb write err:(-7) LIBUSB_ERROR_TIMEOUT
 [2014-06-25 00:22:24] HFA 52 attempted reset got err:(0) LIBUSB_SUCCESS
 [2014-06-25 00:22:24] HFA : send_packet: OP_USB_INIT USB Send error, ret 0 amount 0 vs. length 8
Double check that all the PCIe power cables are properly attached, and then power cycle the unit (with USB unconnected, the USB cable can power the board).