I got a reply from Cointerra and they have been emailing me trying to help. They first replied with I could not send the board or unit in for repair because I opened the unit and voided the warranty. They attached a pdf for trying to fix my problem with instructions that said to shutdown the unit, remove the cable from J11 on the offline board and then power the unit up. If the LEDs start the unit is all good. Leave the cable off and im done. I did this and the LEDs lit up then they immediately turned off in sequence and only D44 and D45(red) LED's stay lit. Cointerra asked me if the ground cable was connected. Yes it is. Cointerra says he has note seen many units with this d44,d45 led issue and is trying to figure out what is causing it. I have not heard anything else.

UPDATE: Just tried this process a few more times again and noticed only D45(red) stays lit solid