Update on my new G-Blade using Rpi as controller with  Starminer software. It's been running over 18 hours now and appears stable except for a power bump yesterday, about 5 minutes outage. I apologize for the photo quality but it's clear enough to see the performance. The latest Starminer release is running  CGMINER 4.3.5

First jpg is temp setup with RPi.


next shot is closeup of  CGMINER display for single G-Blade, shows up a two devices, 0 and 1 each running at 2.8 MH/s at a difficulty of 512


last shot is WebUI.


Hope this has been helpful and Thanks to Scynthetic for link to Starminer.