Post
Topic
Board Mining support
Re: Hacking The KNC Firmware: Overclocking
by
tolip_wen
on 08/07/2014, 04:35:16 UTC
Elenelen

The pic I promised.

Beware NSFW!
Shows VRMs running nekkid in the breeze while quaffing bootleg current at an open bar Wink

http://i.imgur.com/LhXa182.jpg

YMMV
Smiley

nice soldering job n wire management Smiley yep no burnt pcie connectors for you...now ya just gotta figure out how to oc above 500mhz n yer golden...shouldn't take you too long thou Smiley

Thx, It works well.

The other end of the 12AWG wires

http://i.imgur.com/epKz23R.jpg

2kW x 2 load sharing on a single rail.
Runs on 1 in a pinch but at the limit and down to only 89% efficiency.
I got space and more PSU for other Nep but will replicate 2kW x 2.
8kW single rail and I don't need to meet personally at my home.

It has a jacuzzi. (top center)
http://i.imgur.com/jeIRRcw.jpg

Also note (lower right) easy access for small children to experience 120VAC firsthand.
Not TOO easy though, short ones must use available step stool.

And a heated outdoor patio. (or garage)
http://i.imgur.com/itLOTSL.jpg

The business end of the loop running during construction.
http://i.imgur.com/r2Qjrig.jpg

I constructed a pentagon and recited the verse and all that appeared was an empty V8 bottle.
http://i.imgur.com/9T8lRc2.jpg

I might flip the PCB so WB are inside of pentagon with straight barbs for smaller footprint.

I usually refrain from prototype pics, but this prototype is less ugly than most of my monstrosities.
I hope to approach the 'pair of WC Saturns complete with PSUs in one case' level of fit and finish.

YMMV
Smiley