Re: [StarMiner] - ARM controller image for your ASIC mining needs!
Installation and use is pretty simple.
But I do have a question. Got my Thunder x3 hooked up, and in the first 60 seconds the HW is over 2000, should I be worried?
Rate Pool Accept/Reject HW
31020 Kh/s N/A 18 / 0 0.00% 2084
Nothing turns red on the web console till about 6 mins, then its like
Rate Pool Accept/Reject HW
30410 Kh/s N/A 121 / 1 0.82% 12707
But I do have a question. Got my Thunder x3 hooked up, and in the first 60 seconds the HW is over 2000, should I be worried?
Rate Pool Accept/Reject HW
31020 Kh/s N/A 18 / 0 0.00% 2084
Nothing turns red on the web console till about 6 mins, then its like
Rate Pool Accept/Reject HW
30410 Kh/s N/A 121 / 1 0.82% 12707
You can change the "alerts" in the webUI's configuration page on the HW errors. Your reject rate though is quite low, so I would not be too worried about it (this is an ASIC after all versus a GPU). If there was a high amount of rejects with the hardware errors, then I would be concerned.
Happy and profitable mining to all!
