Post
Topic
Board Hardware
Re: Cointerra Hardware Support **Unofficial
by
Mattster28
on 14/07/2014, 16:05:02 UTC
For you guys that are thinking of trying Liquid Pro stop and think about this for a minute. When you go to spread Liquid Pro to the chips you will see it takes a little work to get it to cover the chip. Once you have a thin layer on the chips and you apply a little to the center you will see it flow across the chip. So what's going to happen if you don't apply it to the water block also? Its going to push the Liquid Pro off the sides of the chip instead of flowing between them like it should. You need to break the surface tension on both the chips and the water block by spreading just enough to cover each then putting a drop in the center of the chip before assembling it. Measure out where it needs to be if you can't see the outline of the chips on the bottom of the water block. Last thing you want is for the water block to push it somewhere its not supposed to be. Not sure where this applying it just to the chip came from. Liquid Pro is NOT like regular thermal paste it HAS to be spread!