Yes I did before but
Booth ASICS are conected to Mixer USB.
I want each ASIC to computer
Can I connect 2 Printer cables to each one ASIC to Computer?
I'm not sure I understand the question sorry. You can open your cointerra terraminer up and plug in two usb printer cables to your PC. Each card is seen as a separate device on cgminer.
I am having issues with my beaglebone for the terraminer. Are you saying that I can plug each board into a PC with a USB cable and then run cgminer on my PC to get it working again? If so, that would be an easier solution than trying to replace the beaglebone.
Yes indeed you can, though cointerra pushed me some driver updates that seem to depend on a firmware update that hasn't happened which means the last good working mainline cgminer for it was 4.3.5.
Mind you I've had all sorts of ever increasing hardware problems with my terraminer too and it is now completely offline.