I have a bit of a problem. Hoping someone can help, I'm fine with computers but have no clue when it comes to network addresses etc.
To start with, I couldn't change the routers subnet so I went through a direct PC connection. Logged into the Ant fine & changed to DCHP. The Ant still had 192.168.1.99/24 as the IPv4 address at that time.
Here's where I went wrong perhaps, I had to connect to the internet again to get details for my pool (having to disconnect from the Ants), and since then I haven't been able to re-login to the Antminers. I've tried resetting them and trying to find them via the router, but they are not there. Anyone have any idea what went wrong/how I can login to them again pls?
To start with, I couldn't change the routers subnet so I went through a direct PC connection. Logged into the Ant fine & changed to DCHP. The Ant still had 192.168.1.99/24 as the IPv4 address at that time.
Here's where I went wrong perhaps, I had to connect to the internet again to get details for my pool (having to disconnect from the Ants), and since then I haven't been able to re-login to the Antminers. I've tried resetting them and trying to find them via the router, but they are not there. Anyone have any idea what went wrong/how I can login to them again pls?
Download Advanced IP Scanner and run that. It should find your Ant.
Good advice, but if you do find the IP address is still .1.99 and you can't log into it try a factory reset and plug directly in again. I had a similar problem with my S1 when I first got it. Played around with the settings and couldn't even connect directly to my lappy. I could see it using IP scanner, but couldn't get to the login page because of the different subnet.
I just changed the IP on my miner after to suit my routers subnet (.0.99)
Now doing a factory reset on an S3, I'm a B3'er so I have no idea if this is possible. On the S1 there was a tiny button on the logic board. I'd press it, then turn off at the power supply about 5 seconds after, power back up and it would be back to factory settings.
Hope that helps
