Hi all.  

I'm still at it with the random no-hashing issue I keep having everyday with my Raspberry Pi & now 8 Gridseed G-blades, up from 6 G-blades, new 6FT USB Cables (down from 10 & 15 footers).  And again, I even replaced the hub with a new Turcom 24 Port USB 2.0 Monster USB HUB W/ac Adapter Power Station.

I'm still not sure if this is a BFGminer issue with too many G-blades or not.  
However, it works fine with up to 5 G-blades.

I updated BFGminer to the latest version, as of this writing, to v4.5.0.

Here are my results.




No Over-clocking used. They are setup at their "Sweet Spot" as recommended by most.  See below:



Same thing but from the Minepeon WEBUI below:





See my previous post here, with the same results.


I don't know what else to do.

I get the same thing using Multiminer with bfgminer.  It's always a different G-blade that stays stuck on zero, always & only using BFGminer since all I do is LTC mine with these.



Any suggestions?