Re: The Habanero - 650GH/s - Batch 2 Shipping June 9th, $850 ($1.3/GH/s)
MrTeal,
how is higher voltage affecting temperature of dies.
We have summer time and temps are around 30 degrees C. I'm using H100i with SUNON fans and all I can do is piss poor 525MHz
Previous owner set voltage to 0.91V and he run it at 930MHz or something like that. I can't run that high.
My other two Habs have cheap china water blocks and they run on 750MHZ--0.86V.
Can this higher voltage cause higher temps of dies ?
Thank you very much
Higher voltage will affect the power consumption, so it would be worth dropping the voltage. I find 910mV (shows up in cgminer as about .86 at the die) to be good for around 800mV. I would look at taking off the cooling head, cleaning everything good with isopropyl and reapplying the paste though. Unless the fans are extremely low flow, you should be able to get higher than 525MHz without overheating.how is higher voltage affecting temperature of dies.
We have summer time and temps are around 30 degrees C. I'm using H100i with SUNON fans and all I can do is piss poor 525MHz
Previous owner set voltage to 0.91V and he run it at 930MHz or something like that. I can't run that high. My other two Habs have cheap china water blocks and they run on 750MHZ--0.86V.
Can this higher voltage cause higher temps of dies ?
Thank you very much
What's the model number of the fans?
Board is bent a bit 2-3mm and paste was re-applied 3 times. First I have used Paste supplied by by Corsair and then MX-2.
Fans are PMD1212PMB1-A.
Sometime temp drops for a split second down to 60-70C and then back to 100C.
I don't have Shitnux to lover the voltage
Isn't there any cgminer command I can use to force voltage down ?
Thank you very much for your help