Just wanted to check in here. Couple of days ago, things looked like they were running smoothly with ExecoinJ. My block height closely matched the block explorers for ExecoinJ. Since then though, it looks like I am out of sync again. My block height is not 328,200, where I see the block explorers being only at 313,160. I'm going to presume that I've hooked into a couple of bad nodes again.

I notice that there is an additional new checkpoint in the execoin src that is not in the ExecoinJ src (actually, there are a few differences in the checkpoints src code). Not sure that matters because it looks like the code actually looks for a checkpoints file instead of using the pre-programmed checkpoints. But the checkpoints file for ExecoinJ hasn't been updated for 16 days. Can you post a new one?

Thanks!