Post
Topic
Board Mining support
Topic OP
Rig becomes unresponsive after few hours of mining
by
xloki
on 06/04/2012, 18:47:23 UTC
Here is my setup:

amd 145 sempron /asrock extreme 870
2x1gb kingston ram
4x 5830
700watt gold rated power supply


The rig will mine perfectly on all four cards for a few hours and then become unresponsive. I had originally thought it was a power issue and went ahead with replacing it and then the rig ran fine for awhile until it did the same exact thing. The power supply I purchased, temporarily, was a 850watt bronze rated, which should be enough juice for what I have. I then began to suspect it being a riser cable that I use for 2 out of the 4 cards. Sometimes I would boot up and it would only hash at half the rate or not see the card at all. I isolated which card it was and indeed it was one of the cards on the riser to a 1x pci-x port


It would run perfectly fine for days-weeks on 3 cards mining full blast. I got replacement riser cables and the half hash rate problem went away and all four cards were mining for approximately 12 hours. I have switched back to my original power supply but it still wont run more than half a day with all four cards going.

Is it just my power supply or can someone offer a better explanation? Any help will be greatly appreciated.

edit: I run all the cards at 960/300, which has been flawless in the past.

I have also swapped the cards around so I think all the cards are fine.