If you are located within North American Regioin, Please return this S3 to the following address with a tracking number and PM your shipping address, phone number and the e-mail address in the original shipping box (if possible)
Bitmain Warranty
3700 Quebec St. #100239
Denver, Colorado 80207
Phone: 844-248-6246
Thank you!!
Did you do it this way?
Quote
First: Disconnect the cable connected to Chain#1 to test Chain#2 hash board.
Second: Disconnect cables connected to Chain#1 and Chain#2, turn over the control board, and then connect the Chain#1 to Connector#2 of the control board, to test Chain#1 hash board.
Note: Since there is no +12v in the Connector 1#, you have to turn over the control board to test Chain 1#
Second: Disconnect cables connected to Chain#1 and Chain#2, turn over the control board, and then connect the Chain#1 to Connector#2 of the control board, to test Chain#1 hash board.
Note: Since there is no +12v in the Connector 1#, you have to turn over the control board to test Chain 1#
Thanks to point that out. Those are the small things that the eye sometimes skips.
Gonna test it that way and post the results here.
I turned over the control board and connected the connector #1 to the chain #2. It didn't worked. I quite don't get why do I have to flip the controller over since I see the screws holding it to the case are only grounding the PCB. I checked the cables were connected correctly.
Quick Recap: So far:
- Both Connector #1 and chain #1 connected; Connector #2 and chain #2 connected: Machine boots, Status>MinerStatus>AntMiner is empty. Red and Green leds on.
- Only Connector #1 and chain #1 connected: Machine doesn't boot, fan attached to the chain #1 blows at 100%, the other one 0 RPM. Both red and green leds are off.
- Only Connector #1 and chain #2 connected: Machine doesn't boot, fan attached to the chain #2 blows at 100%, the other one 0 RPM. Both red and green leds are off.
- Only Connector #2 and chain #1 connected: Machine boots, Status>MinerStatus>AntMiner shows the info of the Chain 1. Asic status: "oooooooo oooooooo". Red led off. Only green led is on.
- Only Connector #2 and chain #2 connected: Machine boots, Status>MinerStatus>AntMiner shows the info of the Chain 2. Asic status: "oooooooo oooooooo". Red led off. Only green led is on.
- Only Connector #1 and chain #2 connected, PCB turned over.: Machine doesn't boot, fan attached to the chain #2 blows at 100%, the other one 0 RPM. Both red and green leds are off.
Thanks,
EDIT: Fixing typos.
For faster service i would call if you live in the US trust me i called i had a new one out to me after i shipped off the defective one . the tech even gave me free shipping and told me if got it to ups that day he would ship my replacement once it was in the UPS system other wise i had to pay shipping to them . but he told me not every is as lucky as i was they don't all ways do that . why i say call and talk to them you never know .