Wiring:

• Prepare the paperclip for the PSU's 24 pin connector.
• Prepare the watercooling for the miner.
• Plug in the eight PCI-E cables to the miner.
• Plug in an ethernet cable from the AntMiner to you router.

Configuration:

• Power on the power supply using its switch at the back.
• Make sure that your router's subnet is 1, ie 192.168.1.x. If not then change it to 1, this is just temporary. ***If this is not possible, see below***
• Using a browser, navigate to 192.168.1.99 - this goes to the C1's configuration page.
• Login using "root" as both the username and password.
• Navigate to Network -> Interfaces -> WAN -> Edit.
• Change protocol to DHCP and click "Save & Apply".
• Using a browser, navigate to your router and find the IP it has assigned the C1 and navigate to that IP.
• Navigate to the page Status -> Miner Configuration. Enter your pool information in the below format.
• Select "Beeper ringing" to "false" and click "Save & Apply".
• Navigate to the page "Miner Status" to check mining has started.
• You can then change your router subnet back to whatever you are used to using.

Alternative Subnet Change:

• Unplug your computer from all internet sources.
• Plug in an ethernet cable from the AntMiner to your computer.
• Navigate to Control Panel -> Network and Sharing Centre -> Change Adapter Settings.
• Right click on your ethernet adapter -> Properties.
• Click on "Internet Protocol Version 4" and click properties.
• Select "Use the following IP address" and enter the following:
• IP Address: 192.168.1.1, Subnet Mask: 255.255.255.0, Default Gateway: 192.168.1.99.
• Plug in an ethernet cable from the AntMiner to you router.
• Restart the configuration instructions as above.

Problem	Solution
"x".in.a.row.on.miner.configuration.page	- There is a faulty chip - nothing we can do. Hash rate will be affected by ~1.5%.
Almost all "x" on one row of "Chips"	- A hashing board may be mispowered or faulty. Recheck your cabling and PSU.
How do I change the login password?	- Navigate to System -> Administration. Enter the current password and enter your new one twice.
What is the SSH login?	- Username is "root", password is "admin".
Can I turn the beeping off when the miner stops mining?	- Navigate to Miner configuration and turn "Beeper Ringing" to false.
I can connect to the AntMiner but its not hashing?	- Set the protocol to DHCP via Navigate to Network -> Interfaces -> WAN -> Edit. If you don't want to use DHCP, navigate to Network -> Settings and make sure "Gateway" is set to the IP of your router.
What temperatures should I aim for?	- Try and achieve <50 for best hash rates, and <60 for long lifetimes. Temperatures should not be let to rise above 70C.
Where can I get the latest firmware?	- Download from Bitmain's site.
How can I tell what firmware version I have now?	- Navigate to System -> Overview and look at "File System Version".
How do I install the latest firmware?	- Download firmware as above. Navigate to System -> Upgrade and click "browse". Select the downloaded file and click "Flash image". Do NOT interrupt this process or you will brick the unit.
How do I reset settings to default?	- Use a paperclip to press the reset button - located next to the ethernet connector - down for 5-10 seconds. The miner will then reset with stock settings.
My.power.supply's.cables.are.braided.or.aren't.color.coded!

SD image in case of corruption. | That image is set to DHCP so visit your router to find the IP assigned.

See step by step instructions here.
Or youtube video here.