Very new here.But seem like I'm another the latest firmware as bricked my control board.
It was flashed over WIFI network, and had the message that the firmware was ready to flash.
Now I have the red flashing LED of death.
Latest firmware took on my two other units.
I'm able to open a telnet connection on the old IP address, but that is it. I'm lost from here.
I see some HEX stuff going on, but it is way beyond me. Is the hex file able to be flashed through ethernet?
Any solutions to get firmware flashed over again maybe over LAN1, Debug???
If you can telnet to the miner all hope is not lost...does it allow you to log in to the miner using telnet?
You can use serial connect instructions are here....
https://bitcointalk.org/index.php?topic=889206.0Ok, let me clarify. Telnet connection over putty, to the old IP address over Ethernet, is the only one that doesn't say connection failed. I don't know if I actually have a connection. I still get a blank screen