You didn't seem concerned that the controller version was blank before. This is where you are supposed to get your firmware version according to your guide. So, that tells me something is maybe wrong with it. So, I tried to reinstall the firmware. I did it from within the openWRT portal and nothing changed but it seemed to work ok. Controller version was still blank.
I saw your note where I should just reflash the SD card. So I tried that, and now I can't even get it to connect to the internet.
And then I just wrote that to my SD card. Was that the right one?
ugh... I hope zoomhash either lets me open up the case or will accept this back and return my money.
I used Win32DiskImager to write "openwrt-brcm2708-sdcard-vfat-ext4.img" to an SD card and inserted it into the Rasp Pi. I connected an HDMI and nothing boots up. The RaspPi turns on but no OS loads up. Am I doing something wrong? Do I need to install the RaspPi OS individually or something now?
I was trying to setup the Avalon to run wireslessly but now I can't even get any OS to boot up.
I would like to be considered for a Avalon6, not sure if my initial request made it through to anyone.
One for right now. If the 6 proves as solid as the 4.1 I will most likely purchase another one.
Post
Topic
BoardHardware
Re: Avalon ASIC users thread
by
bigredbutton
on 08/11/2015, 23:57:57 UTC
The entire back panel of lights on one of my Avalon 4.1 is all lite up and blinking in unison. ERR, WARN, TXD etc. solid and pulsing in unison. I took the unit apart and nothing appears out of the ordinary. Any recommendations on trouble shooting?
Post
Topic
BoardHardware
Re: Avalon ASIC users thread
by
bigredbutton
on 06/11/2015, 03:18:51 UTC
Put me down for one as well philipma1957 my good sir. Thanks
Post
Topic
BoardHardware
Re: Avalon ASIC users thread
by
bigredbutton
on 05/11/2015, 12:19:06 UTC
I am also interested in participating in the Avalon6 group buy if any of the units happen to not be spoken for.