Search content
Sort by
Showing 13 of 13 results by cryptojacker
I have modified the hardware (upgrade 8G memory) and software and E3 works again.
Hi! How exactly did you do the Antminer E3 modification? How many chips did you swap and what did you do to the firmware? I am stuck at a crossroads on this experiment. Please share details. Thank you!
I have modified the hardware (upgrade 8G memory) and software and E3 works again.
Anyone know details on this? Thank you in advance.
I have modified the hardware (upgrade 8G memory) and software and E3 works again.
Hello! You succeeded with the E3 RAM mod? Would you tell me what you did exactly as I have been attempting to do this myself and am at a crossroad. I've been trying to figure it out since last year. What did you do? Congratulations and thanks a lot! Please turn on the ability to receive direct messages. I tried to message you and got a message to post here.
Hello! Too many pages. My eyes are crossed. I have a D3 with a dead board. Is there anything I can do to bring it back to life? It worked fine at first. Nothing looks burned. Thanks for the help.
Please try to run it with only that board connected to the first chain connector. Try to swap PSU / chain cables to see if it gets detected. Try to start at default voltage (13) and set a low frequency to see if you can get it working (200Mhz).
If that works: decrease voltage / increase clockspeed slowly until you found the sweet spot
Blissz, no go. chain 1, 200mhz, 13. Stepped up to 14, 15, 16, 17. Nothing. The other two cards run fine when connected. The machine is out of warranty. Please advise.
Hello! Too many pages. My eyes are crossed. I have a D3 with a dead board. Is there anything I can do to bring it back to life? It worked fine at first. Nothing looks burned. Thanks for the help.
Hello, i don't know much about this firmware yet but software aren't fixes for hardware issues, try lowering clock and check input voltage. I have tons of people that ask me for gpu bios mods to fix hardware issues and it's only ever of use for stability issues caused by improper voltage.
I am asking because the L3+ thread I read says putting some firmware on a micro SD card may do the trick for them. I have the D3 only connected to the unrecognized hash board. I set it to 100mhz, lowest setting, and fans are AUTO silent. And what happens is the fans spin up to max and seem to stay there. When I plug in the other boards only everything works fine. Changed up the cables and even swapped controller boards and everything checks out. Just this one hashboard that stopped working.
Thanks again for any help. Additionally, I asked an electronics guy in town to take a look at it and he found that some parts were registering as having resistance (or not) that were counter to what he had been taught. But then checking the same parts on working boards boards they did the same thing. He said the Chinese have weird ways of doing things. He was asking for a schematic of the board but I never found that. Is this thing dead dead dead or can it be resurrected. Thanks!!!!!
Hello! Too many pages. My eyes are crossed. I have a D3 with a dead board. Is there anything I can do to bring it back to life? It worked fine at first. Nothing looks burned. Thanks for the help.