Quote from: PhoenixMiner on November 29, 2018, 07:20:04 AM

Quote from: john1010 on November 28, 2018, 10:01:44 AM

This is my first time to use your miner after reading all the comments here, they got my interest in using your it, by the way is my command line is correct? I am using 12 rx 570 4gb in 1 rig.. with win10 18.6.1 radeon, all cards are moded.

here's my command:

PhoenixMiner.exe -pool mine.house:7007 -wal 0x3d046******** -pass x -clgreen 1 -fanmin 45 -fanmax 70 -worker ** -coin dbix -stales 0 -cdm 0 -amd -acm

All of your help will be appreciated..

Thanks Wink

Result:

My rig crash every 3-5 mins running.

The command line seems fine. As the crash happens after the mining has started perhaps the overclocking settings of the cards are too high. In the first few minutes the miner will perform auto-tune as there is not explicitly specified -gt parameter. You can try the following things to fix the problem:
* Start the miner only with half GPUs (add -gpus 123456 to start with 6 GPUs only) and see if it still crashes. If not, wait until auto-tuning is over (it usually takes less than 5 minutes), press 's' on the miner console window and write down the -gt values (they should be fairly similar if the GPUs are the same). Then try to start the miner again with all GPUs but with added -gt parameter (e.g. -gt 45 if the best found -gt parameter was in 43-47 range for the individual GPUs).
* Lower the memory clocks and/or increase the core voltage sligthly.
* Try using the non-green kernels (remove -clgreen 1) or try using the alternative kernels (-clkernel 2)

Quote from: aarts on November 28, 2018, 11:47:30 AM

-proto 3 does not work with 4. starts with default proto setting.
alsos if press c on miner screen(reload config), it starts miner in dual mining mode. i haven't set up dual miner.

Thank you for reporting about the problem with the 'c' key. The message about switching to dual-mining mode is harmless but we fixed than anyway in 4.0b.
-proto 3 works as before for us. Can you please send us a command-line example where it doesn't work?

Quote from: asukahan on November 28, 2018, 11:08:43 AM

I'm using HIVE OS 0.6 now, all my AMD cards works like charm with Phoenix miner, but none of my Nvidia cards work with Phoenix Miner,

I tried parameters like:
-nvidia
-gser
-nvNew
-nvf
-coin

for sure I added 0 or 1 or value after them, but nothing works, cards can be initialized but no DAG log shows, hash rate stay at 0, nothing happened until miner restarted.

Can you please send us the log for the first 1-2 minutes? We are unable to reproduce this problem here.

Problem solved after Hive OS upgraded today to 0.6-04 with Phoenix Miner 4.0a

asukahan

Posts

Merits