Quote from: Kukus on October 13, 2017, 02:34:39 PM

I have 2 issues with Claymore 10.0 (Win10, blockchain drivers, 6card rigs running 570 and 470 cards)

1) After initial rig start (i.e. after powering or resetting the whole rig) Claymore 10.0 runs with lower hashrates (for example about 23-25Mhs with 470/570 cards). After stoping the miner and re-run .bat, I getting normal rates (i.e. miner has to be restarted and operates as expected only after 2nd run, never from the first)

2) Unpredictable hashrate drop during mining for some cards in rig (usually 1 or 2 of them). Rate drops and keeps at 23-25. The only solution I found is to restart Claymore.

Any comments guys?

1) I have noticed the same thing. I always have to start the miner, close it, and start it again for best speeds. (rx 580 gpus)
2) I get rate drops from 29 down to 20 and back up again...haven't noticed them staying at 20 here.

The only issue I have here is I have been getting gpus hanging, causing the miner to restart and my rig (sometimes) just up and restarting for no apparent reason. I assume right now that it has nothing to do with the miner and everything to do with the blockchain driver and my power supply running out of juice. As I've lowered cclock on each gpu, both the hanging and restarting have gotten better...to the point where I am almost stable now (I make small adjustments). If the blockchain driver is causing power spikes, that would definitely explain my issue.

AcrylicGuy

Posts

Merits