Quote from: NCarter84 on October 25, 2019, 05:36:47 PM

Quote from: 1033ruben on October 25, 2019, 03:42:47 PM

Quote from: 1033ruben on October 25, 2019, 01:25:11 AM

Quote from: NCarter84 on October 23, 2019, 06:11:42 PM

Quote from: 1033ruben on October 23, 2019, 02:10:15 PM

Quote from: christiano88 on May 12, 2019, 03:28:03 PM

I am getting a hard reset everytime I try any of the straps. I have testing mode enabled, secure boot off, driver 19.4.1 installed and 8 hynix rx580 8gb cards on win 10. When it goes to apply straps, it gets to the point where it shows the strap has been applied to the 2nd card and then...boom, reset. Tried with all levels of strap (1->5). I am setting the clocks with overdriventool externally, at 1751mhz (pretty low for testing sake).

The same thing is happening to me.I am at my wits end with this rig PLEASE SOME ONE ANYONE HELP!!! so i have a 6x rx rig with 4 x470 and 2 x570 all 8gb. ok so like a few days ago it crashed right and this is after a month of solid mining with no resets or reboots or crashes. so things that i have tried i replaced the psu with a 1200 watt seasonic prime which is more than enough, i also switched out mobo from a gigabyte h110 dm3 to a asrock btc pro, i have tried lowering the clocks, i have tried mining on just the rx470s and the 570s all to no avail, the only thing i havent done yet is switch out all the risers i am waiting on mine to arrive which is tomorrow. but i highly doubt that will fix the issue as i am able to mine with phoneix miner but the hashrate is pretty shittty. i mean going from 191 mh/s to 90 something is unacceptable. so please any one some one please help i am open to any suggestions at this point.

Have you tried to DDU yet?

yes tried that multiple times with a gang of drivers and even went as far as too reinstall windows on a different ssd and all...
ANYONE HELP!!! Please

So then nothing huh...

Going from 190 to 90 mhs = your drivers aren't in compute mode.

Honestly, PM is faster overall.... Set drivers to compute, download the tweak tool and set tref to 30 and see where you end up.... My (6) card rig of 470s run 197 mhs on PM.

ok nm i got them to run on Phoenix Miner turns out one card is bad now getting 158 on Phoenix Miner but still geting the pc reboot everytime i try to run claymore 15, on the known good cards, man what can it be and now my other rig which is a 8 x rx570s is not letting me run the 8th card i mean it will load the memory timings and everything but when with the other 7 cards it'll crash but when ran alone with the -di option it will mine. man these rigs are starting to make me pull my hair out.
ANYONE ANY IDEAS PLEASE ANYTHING IS WELCOMED!!!
RECAP:
Issue 1= on 6x rx 470 rig reboots the entire mobo/pc when it starts to load the straps.
Issue 2- on 8x rx 570 rig will run 7 out of 8 cards with claymore, however when mining with 8th card alone through -di 7 option it'll mine just fine.

Please help anyone!!!

1033ruben

Posts

Merits