Quote from: imine2 on September 30, 2018, 04:46:27 PM

Quote from: Dobryj77 on September 30, 2018, 03:47:09 PM

Quote from: imine2 on September 30, 2018, 09:14:03 AM

Quote from: Dobryj77 on September 30, 2018, 08:16:12 AM

Hello, I changed the firmware to batch 1 after 24 hours the miner was cut down and no indicator is working. Now I can not enter the admin panel of the miner. Can you tell what can be done about it?

fan running Huh

heat?
Power working at all Huh

?

Yes fan and power supply working.
Do you think that I can try to recover from the SD card Huh

Have you tried this method?

https://support.bitmain.com/hc/en-us/articles/115003595387-How-to-reset-miner-to-factory-settings-
(Depending on where your SD-cardslot is placed you will use method 1 or method 3, read instructions in link for method 1 and 3 to decide which alternative is valid in your case.)

Recover from SD-card should be last option, I think!

Hi. The miner does not start the SD card not work indicator light, but the cooler is spinning.

Dobryj77

Posts

Merits