Quote from: Jake36 on May 04, 2016, 03:37:12 AM

Quote from: kupan787 on May 04, 2016, 02:04:59 AM

Quote from: sidehack on May 02, 2016, 12:59:11 AM

If you've got a volt meter, measure the voltages on the testpads on the back. Measure the core voltage when it's first plugged in, and then when cgminer tries to start mining with it, and see if it changes. That'll let you know whether it's an ASIC issue or a power issue.

So I used my volt meter on the good stick, and got a reading. So I knew I was doing things right. I plugged in the "bad" stick, green light comes on. Check with volt meter shows 0. Start up cgminer. Still shows 0. Let cgminer do its thing, and try to hotplug. Still shows 0. Test the volt meter against my good stick, and I get readings.

So does this mean the asic is bad? Or maybe something blew? Like I said, all was good until I did a reboot of my PI the other day. Now only one stick is good.

Anything else I can try and test to see if I can diagnose it?

When you checked, did you plug the no reading 1, it into a different slot on the hub or into the same slot as the stick that you got readings on? If it was in the same slot, that would rule out something in the hub going out.

Tested them both direct connected to my laptop, so no hub. Wanted to rule out anything I could that might cause an issue.

Tried both USB ports on the laptop just to be sure. Same results.

kupan787

Posts

Merits