Quote from: dEBRUYNE on Today at 12:53:50 PM

Quote from: DStefanov on June 04, 2020, 06:27:03 PM

Quote from: dEBRUYNE on June 04, 2020, 03:25:45 PM

Quote from: DStefanov on June 03, 2020, 08:27:15 AM

Quote from: bitebits on June 03, 2020, 05:51:40 AM

@DStefanov you likely need to do a ‘sweep_unmixable’ because of having old non ringct outputs:

https://monero.stackexchange.com/questions/3508/what-does-the-sweep-unmixable-button-in-the-current-version-of-the-gui-do#3517

https://www.reddit.com/r/Monero/comments/8bilrs/comment/dx7in2o

I understand, but the "sweep" option is activated !!! I guess everyone sees this !!! In my case, what else should I do?
When I press the "sweep" button it gives me this error:

Can anyone describe step by step what I need to do to withdraw funds from this damn wallet?

The error message shows that the 'unmixable' outputs you possess can only be transferred whilst using a local node. Which operating system are you using? Then I can provide specific instructions.

The operating system I use is Windows 10 Pro x64.
Thank you in advance @dEBRUYNE.

Try these steps:

1. Close all Monero related software.

2. Reboot your system.

3. Open monerod.exe

4. This will start the sync of the local node. You can type status into the command prompt window to get a status overview. If you have to exit the software, make sure to type exit in order to stop it gracefully.

5. Note that you can sync periodically. The sync will simply pick up where it left off.

6. Once you are fully synced, you can open the GUI (the GUI will automatically connect to the daemon (monerod) that is running separately).

7. You should now be able to perform your transaction.

Let me know if you have any further questions.

Thank you for the instructions. I let it sync, but obviously it will take a long time. The only thing that impressed me was that monerod.exe had to run it as an administrator.
Once it syncs I will write what I did
Thanks a lot @dEBRUYNE.

DStefanov

Posts

Merits