Quote from: bark0de on December 19, 2013, 11:02:23 PM

Quote

What power supply are you running?
What mining program are you running & stratum proxy?
Any other relevant information you could share? Like, what is the LED doing? What does the web interface tell you.
What do you mean they "restart". I assume they continue to run in standby mode? If you prefer to keep this on the public board. feel free to quote this and reply back on the board. cheers.

My power supply is a Corsair CX800
I am connecting the blade and the cube via slush's proxy (since I can't seem to get the BFGminer proxy to work right)
I have tried both slush's pool and BTCGuild (i prefer BTCGuild)
They blade and cube are properly cooled in a server room with dedicated AC kept at 60 degrees F and fans blowing directly on them
They are connected directly to a dedicated DSL line (not the best, but I chose to do it this way because it bypasses my company firewall)

I haven't actually sat to observe the status LED, but I just went down now to check it out and I just see it blinking repeatedly.

They will hash fine for about 10 minutes and then they just suddenly stop receiving work. When this happens, I see on the mining proxy that it stops showing the messages where it shows the username for the blade and the username for the cube doing work, and it only shows messages like "new job xxxxxx" which seems to me like the proxy is still requesting jobs from the pool, but it's just not passing it to the ASICs for some reason.

On the web config, I notice that the running time for both the blade and the cube are always the same, meaning that they are restarting themselves at the exact same time.

My blade is the new blade model. My cube is from CanaryInTheMine's most recent batch.

I hope this is enough information

Is your IP for the proxy static?

midniteslide

Posts

Merits