Quote from: margotcoins on October 07, 2019, 10:23:52 PM

not that I can tell, here is what I get when starting cgminer, I would say no error beside the no device found...

Based on what you're telling me, The miner appears to be detected MacOS. take a look at this procedure to remove the VPS modem driver:

https://bitcointalk.org/index.php?topic=5053833.msg50638400#msg50638400

Quote from: margotcoins on October 07, 2019, 10:23:52 PM

You mentioned this branch to cgminer, I am just a little confused.
Should I run the Homebrew code you guys talk about on the first page ?
And then your branch ? Or just run your branch code ?
I am asking because I don't understand the code .. so not sure how to proceed, thank you!

please read the above link again - it has the exact command you need to compile the r606 branch of the mining software.

Quote from: margotcoins on October 07, 2019, 10:23:52 PM

well, it's actually a hackintosh I put together, the identifier was installed as a iMac late 2012 running 10.12.6, I wanna say 13,1 but could also be 13,2 (21 vs 27 inch imac)...

When you mentioned swapping from USB2 and USB3 i figured; imo if you have the technical expertise to setup a Hackintosh, I would recommend you dual boot into Ubuntu on a separate drive. it will be far less PITA to troubleshoot on your exact, same hardware. Even the Identifier (e.g. imac13,1 imac13,2 imac14,2) you picked in Clover can make a huge difference as to how ports are addressed, and is typically hardware-specific to your motherboard and chipsets. I can help out with mining on MacOS, but troubleshooting hackintoshes is out of my wheelhouse.

kalus

Posts

Merits