Quote from: ineedit on December 28, 2013, 05:58:05 PM

Quote from: FreeGiz on December 27, 2013, 07:51:44 PM

Quote from: ineedit on December 27, 2013, 06:15:24 PM

Quote from: Xian01 on December 27, 2013, 03:56:29 PM

Quote from: FreeGiz on December 27, 2013, 03:50:45 PM

WWAN not accepting remote login
the eth1(WAN) setup fine, luci & SSH login fine.
I set additional Wifi(WWAN) & firewall(WAN/WWAN), the internet link is fine & hashing can confirm by pool. how ever I can not get login if only wifi is connected. both web page (luci) & ssh login did not have response from antminer.
anyone have idea? Huh

I have no idea, but if it's any consolation, myself and others have run into similar behavior with the WWAN interface.

I've not been able to properly configure the WWAN's on any of my Antminers Sad

Afraid I'm going to hose the network settings and not be able to get back into the device if I screw something up while troubleshooting Sad

Seeing the same as you; not able to access config over WIFI, only via WAN.

I have a couple of the next batch of Antminers on order that I understand now have a factory reset button - I'll troubleshoot further once I have that safety net available.

Same problem, although I have found that wrt doesn't like having both wireless and Ethernet on the same subnet but even with different subnets the problem still occurs.

in case you miss my update, my wifi/WWAN login did works (back to live) after I power-off and power-on cycle.
but seems using REBOOT command(ssh) or bottom(web UI) would not enough.

I have tried with a power cycle, and did it again just in case I screwed it up first time, I just end up timing out at the Lua LuCi Interface black screen before you can login. Would you care to share your /etc/config/network file?

I am currently under eth1, maybe later by PM.

another hint, I found that I need to apply hostname of WIFI interface to make my router always assign same ip for antminer.

FreeGiz

Posts

Merits