Quote from: 0m3g4 on March 01, 2014, 12:14:25 AM

...I recently re-installed windows on a new system. Now I can't get to the config page at all, I tried the default 192.168.1.254:8000 and what I changed them to 192.168.1.200-203. I didn't have to change any router settings previously, but now i have gone in and enabled dhcp range to 192.168.1.100-254 still no luck.
...
My setup is DSL modem/router to a tp-link router, the DSL modem gateway is 192.168.0.x, but I have my tp-link router set 192.168.1.x. I would think since these all talk via the tp-link router, they would be operating on the 192.168.1.x like they should be, I just don't see them anywhere on the network...

If you reset the cubes, then they are at 192.168.1.254:8000
If the cubes can not be seen on the network, then the sets of ip's (computer|gateway|sub-router|cubes) do not match.
From your computer, set the ip of your gateway to 192.168.1.1
If your computer is different from 192.168.1.x, you will lose the network.
Now change the ip of your computer to 192.168.1.2, you will regain your network after this change and be able to see the cubes.

To return your network ip to the original settings:
change the ip of the cube(s) to 192.168.0.10x (101,102,103,104)
(you will lose the cubes from the network at this point)
change the ip of your gateway to 192.168.0.1
(you will lose your network at this point)
change the ip of your computer to 192.168.0.2
all cubes will be available to the network at 192.168.0.10x (101,102,103,104):8000

DNS capabilities in your gateway, sub-router, and computer can override these settings
If Auto DNS is enabled, the parameters of the ip settings must fall within the DNS range
I have auto DNS enabled and have specified the range to be greater than the parameters above.

if you have two routers and they have different ips, the items plugged in the sub-router will be inaccessible from items plugged in the main router
-I note that you have 5 items to plug in (a computer and 4 cubes). If the computer is in the main router|gateway and the cubes are in the sub-router, the ip's must be in the same ranges to see each other.
Re-installing Windows likely reset the ip on your machine to one that is different from your original set-up, causing the disconnect.

I figure you know how to actually change all these settings, if not, do ask.

BTC:15uVW7sJHFvM8Lnan3gCvnNoFxxycDBPUC

JustJeff

Posts

Merits