Quote from: philipma1957 on June 08, 2021, 09:58:58 PM

Quote from: jstefanop on June 08, 2021, 09:29:41 PM

Quote from: jbrow8 on June 08, 2021, 01:11:28 PM

Well it worked for about 15 minutes, got a pool started and soon the red light went solid and I could no longer access the device, the IP address no longer shows up.
Found the IP address after rebooting and now refuses to connect
- after hooking up a monitor and keyboard, nothing to see here, but the miner suddenly starts mining again and I can access it again. Its still in eco mode, Node syncing is about half way finished now, Did something overheat or is the dynamic IP address a problem?

Locked up again after maybe one hour, cannot access with a monitor or through the IP address, no mining is happening on the website and the the blinking redlight and heat from the unit means its doing something, (using electricity).

They system might lock up a few times while its syncing, it should resolve by itself. Node uses up 100% of system resources, mining has priority though and should not stop. If you want to avoid these issues I would recommend you stop mining for ~24 hours while the node completes most of the syncing.

If your in a hot environment it could be that the CPU is overheating and shutting down. While we did extensive tests during syncing and running in ECO mode, it would overheat in certain situations while in Balanced/Turbo.

My node is synched.
I am running eco
my hash board temp is 54c
but my cpu temp is always over 70c
mostly closer to 75c

so on the cpu temp is long term 75c okay what to watch for on cpu temps.
80c?
85c?

If I recall ARM cpu can run hot 🥵 safely.

oh room temp is 75-80f

Finally managed to get back into system, the node did not sync after another 30 minutes. I did manage to get the mining running again at 2 Th/s, its been running about 15 minutes now. The sync message just states waiting it may take 15 minutes, when before the sync menu was there and the graphics show 10/31 and actively syncing.

jbrow8

Posts

Merits