Quote from: deepcryptomine on November 27, 2017, 06:53:35 PM

Quote from: junghansmega on November 27, 2017, 12:50:33 PM

Quote from: deepcryptomine on November 27, 2017, 03:52:24 AM

Quote from: deepcryptomine on November 26, 2017, 07:44:45 PM

Quote from: skdsw on November 26, 2017, 10:36:01 AM

Quote from: deepcryptomine on November 26, 2017, 09:46:42 AM

Quote from: skdsw on November 26, 2017, 09:40:12 AM

{
"outpoint": "xxxxxxxxxxxxxxxxfb3c3392bxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx",
"service": "79.165.207.31:9919",
"payee": "D9xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxSN",
"status": "Masternode successfully started"
}

Is it means that my masternode is running?
How to check?
Strange wallet without any masternodes tab

No any info about nodes list
No any way to check

Wallet shows masternode started - masternodes.online service shows no any masternode )))

Baddest wallet in the cryptoworld for masternodes

Exactly. I cannot confirm either. My output is similar to yours but masternode.online shows no masternode for the IP or key.

Is there a way to verify if masternode is running properly or not?

type masternodelist and you will see all outputs and its status
my has status "WATCHDOG EXPIRED"
going to smoke this watchdog ))

Thanks. My status was WATCHDOG_EXPIRED". So I installed sentinel and rebuild the block chain. Now the status is enabled for the past hour.
However when I went to my regular wallet and checked the MNs, my MN comes up with status NEW_START_REQUIRED. Is this normal? If it is not then how do I resolve it?

Ok so I had to delete mncache.dat and mnpayments.dat from my local wallet. Now the MN status shows up as 'Enabled'.

By the way I got my first payment as well.

I still get WATCHDOG_EXPIRED. Tried deleting these 2 files and rebooting / restartig everything many times over to no avail.
What could be the issue here?

masternode as such looks good:

Code:

desire@myhost:~/desire$ ./desire-cli masternode status
{
"outpoint": "5a8XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX0fb024932-1",
"service": "XX.XXX.229.166:9919",
"payee": "DXXXXXXXXXXXXXXXXXXXX9",
"status": "Masternode successfully started"
}

I am out of things to try...

I guess I am not getting any payments while WATCHDOG_EXPIRED?

Someone mentioned that they do get payments with WATCHDOG_EXPIRED. Those files I deleted was for the different issue. Can you tell me more about your set up? Are you on Windows? Is sentinel running?

After I got the WATCHDOG_EXPIRE error, I installed sentinel. Deleted all the files from Desire except wallet.dat and desire.conf and started the wallet. After that start sentinel. Wait for the wallet to sync fully and then check the MN status.

I am running a linux masternode including sentinel and a windows wallet. Have been running for about 24h now and still no payment. I restarted a couple of times because of the "WATCHDOG_EXPIRED" status.

Weirdest thing I just noticed: When I close and reopen my wallet the status actaully does go to enabled FOR THE TIME THE WALLET IS SYNCING. After the sync is complete it goes right back to watchdog_expired. I am starting to suspect it migt be a network issue between my laptop(windows wallet) and my vps(linux masternode).

junghansmega

Posts

Merits