Quote from: doktor83 on August 04, 2018, 06:19:46 AM

Quote from: pehoko on August 03, 2018, 11:04:10 PM

Quote

GPU0: AMD Radeon R9 200 Series [Hawaii] [4096 MB][Intensity 236.0][W: 8][T: 1][K
: 1][BUS: 3]
GPU1: AMD Radeon (TM) R9 380 Series [Tonga] [4096 MB][Intensity 236.0][W: 8][T:
1][K: 1][BUS: 4]

---------------------------------------------------------
SRBMiner Cryptonight AMD GPU miner 1.6.5
DevFee only 0.85%
Press 's' to get some stats
Press 'h' to get some hashrate
Press 'r' to reload pools
Press 0-9 to disable/enable GPU while mining
Give it a few minutes to reach maximum hashrate
---------------------------------------------------------
Total pools: 1

Please wait...

Cryptonight LiteV7 mode enabled

[2018-08-04 02:01:34] Heating up system, please wait...
[2018-08-04 02:01:34] Compiling kernel for DEVICE BUS ID 3 ...
[2018-08-04 02:01:35] Error CL_BUILD_PROGRAM_FAILURE when calling clBuildProgram
for DeviceID 0 (Thread 0)

Stopping miner...Uno momento

What is wrong kernel 2 is set?
... solved with newer driver but rig hangs badly on start, other miners working very bad (no 3d) so I am backing to my old driver.

You see up there in the gpus line it says K:1, that means its using kernel 1, not kernel 2. You must set gpu_conf in config.txt and there you set kernel/card

tongas should use k1, the r9 200 should use k2

Tnx, miner works, what about intensities and worksize? Now I am on 0 and 8 but seems not fast, both two card are mining slower than my older Tahitis.

pehoko

Posts

Merits