Quote from: usao on August 22, 2017, 03:08:38 PM

Quote from: IOTUSA on August 22, 2017, 02:40:24 PM

No. You should split the cables (the slide apart) and use ONLY one cable. Connect that single cable from the top-left to the top right (If you use the left controller). That's it. You only use the bottom ports or more than one cable if you serialize multiple units. Baikal can provide you with a PDF of the correct setup.

In short. They provide more controllers and cables than you need for single unit setup. You should only use the controller that was attached when the unit was delivered, the other one is spare. Use only one cable running from the top port of the 'controller side' to the top of the slave side.

If I make it to my office today I'll send you a picture of a correct single unit setup.

Ok, ill try that when I get home tonight.
1) Split apart the supplied cable into 2 cables.
2) Only use 1 instead of both sets of connectors, going from TOP to TOP.
Correct?

Correct. And yank out that second controller unit you mounted on the second board. You should only run ONE controller/network to the unit, no reason to use both and it would unnecessarily require you to run dual network and treat each board as a separate unit.

IOTUSA

Posts

Merits