Quote from: Finksy on March 01, 2015, 01:10:42 AM

Quote from: dmwardjr on February 28, 2015, 11:18:52 PM

Thanks, I suppose I need to get in touch with someone then. I have another rig that I cannot connect to at all. I know I have the correct IP address on it but it will not let me communicate with it. It just says the server will not let me connect to it.

Any suggestions on that one?

I had a couple that would not connect through the SP-tech myminer.io landing page, even though they were showing the miner and IP. I was able to connect directly to the miners one at a time using tftpd32 as a dhcp server from Windows (disconnected from my LAN), pinning a static IP to the miner and all the pool/asic settings. Put it on the network and it was G2G. I think the IP my router had assigned to it initially had a conflict or something. It's something simple you can try before moving on.

Edit: unless i misunderstood and you already assigned the static IP, in which you can either do as the other gentleman recommended or do an SD card recovery and start over.

I'm going DHCP and my Airport Extreme BaseStation does not show me what IP Address it assigned to it. However, I know how my browser reacts to an authentic IP address versus one that is not. Myminer.io gave me the IP as it did all 14 other rigs. I could connect to all of them just fine except for this one.

I have my Airport set up for DHCP and NAT

Wonder if I should do DHCP only?