Quote from: tolip_wen on April 01, 2015, 02:07:14 AM

Quote from: bgibso01 on March 30, 2015, 09:01:31 PM

HELP!

After a solid week of mining, my Neptune controller won't recognize my cubes. I have to be missing something simple because I now have 2 controllers like that. I've used recovery SD to RC6, updated to 1.00, 1.02, 1.05, 1.06s and none will see the cubes.

Instead of white flash that's about a second, I now get a short white flash 3x spaced out over probably 15 seconds. No green led Sad

I'm sure this must be common, so what am I missing?

PS: All ribbons are firmly attached. Red strip towards corner of cube and groove in controller. I've tried just one cube and still nothing.

If by "won't recognize my cubes" you mean you can view miner webpages and controller but it will not detect ASIC cubes, I doubt it is a BBB issue.

No web page or ssh connection to miner, suspect BBB.
If you can connect to controller but it will not see cubes, suspect FPGA on controller board.
Have you tried the controller with no cubes connected?

While troubleshooting remove the LCD and try without it.

YMMC

Well, I'm getting answers all over the place. Sad

This is bonus, so no LCD. Yes, get GUI and can ssh. With or without cubes, same response. I hope its not the controller board. That may prove hard to replace.