For anyone that has done the up/down cable, is there anything special i need to change in my run commands? I know i have to connect the cable and set the master/slave dip, but is that it, does the dual stack just present as 8 com port as it would do individually?
The way it currently works with the newest controllers is:
Previously you had 4 ports per board, but only 2 of them were used for mining (1 port for each Icarus Style Pair of chips).
With the new ribbon cable in place, the second board uses the other 2 ports on the first. So you plug the USB into one board, chain a second board off of it, and use all 4 ports (each port representing 2 chips Icarus style).
Does that help?
Other than following the instructions from Enterpoint (I believe some dip settings) there is nothing else fancy you need to do, just use it like normal, just use all 4 ports instead of just 2.
Hope that helps!