Quote from: notlist3d on May 10, 2015, 12:40:17 AM

Quote from: luthermarcus on May 09, 2015, 11:07:16 PM

Quote from: brianoakes on May 09, 2015, 10:08:26 PM

Howdy!

I have 2 S4's that all of a sudden stopped mining. They are stock settings, no voltage change and I have tried a few different firmware's and they all show the same behavior. When I look at the Miner Status tab, all the values are blank.

The display on the front shows the correct IP. I have tried a few different pools, but no change.

Any suggestions?

Did you just happen to get your 2nd miner recently? If so disconnect one miner and see if it runs by itself without stopping.

I think it's odd for two to go exactly at same time. I would agree try running one. Maybe try another electric outlet on different circuit. Unless you are just really having bad luck and have to give out at same time.

After that I would try to load firmware to see if it changes anything, make sure to keep settings. (there is always risks with updating firmware). But that would help rule out software.

Push in the reset button and hold for a few seconds. This is typical for my S2's when I'm changing pools often. Check to see if your at the current firmware. When you reset if you have a static ip you'll need to go back and change it. If your not running static ip's you should be.
Set your ip outside your dhcp range ex. 192.168.1.200