Quote from: aarons6 on June 13, 2015, 08:36:24 AM

Quote from: Vorta on June 13, 2015, 08:28:25 AM

Quote from: aarons6 on June 12, 2015, 04:18:43 AM

i got my set today from jstefanop.
they look just like the OPs.. mine came black.
i was only able so far to put the top and bottom plates on as i coudlnt find the right size screws for the fans...

You can use original screws that came with the miner, just get them though your fan as described in the first post. If you can't get them through the fan, you need screws that are 40mm + fan depth/thickness. M4 thread.

i dont think the fan screws are long enough?

i guess i can take it apart and check.. but i figured they were too short to go through the fan and the fan shroud.
.

If you got the screw through this way, it will be long enough:

http://www.pohrani.com/f/3c/cg/2t6rfdZa/04.jpg

This is not intended to be used with the stock fan, but it will work.
The temperature readout will be more accurate, thus a bit higher than before.