Quote from: Meech on August 17, 2015, 11:50:14 AM

Quote from: FreeFelix on August 17, 2015, 09:54:25 AM

Quote from: FreeFelix on August 10, 2015, 09:43:17 AM

Quote from: FreeFelix on August 07, 2015, 02:20:03 PM

I'm in the UK so no issue with the voltage all 240 Wink

Dear All

If thinking of buying this PSU for an S4 with the older M4 ring terminals, this is the reply I received from Bitmain.

Hello sir,

when you are making order,

you need to make a comment that you need M4 ring connectors. that way factory will prepare everything and ship.
but please be sure that they have understood you fully. and that you do not need bunch of 6 pins.

send them a picture if needed, that you require type 1 (m4's with one 6 pin). or red cables.
just be crystal clear. so they do not mix order.

Hope this makes it clear how to order

good luck

I just received my APW3-12-1600 PSU that I want to connect to my S4 that has the M4 ring connectors.
Even though I mentioned this when purchasing as suggested by support the PSU arrived with PCI connectors.
However I did come with a power adaptor board.
Can you send me instructions as to how to connect the original cables to this board.
Also the APW3-12-1600 PSU has 12 PCI connectors and the board has only 8 connectors.
Which ones do I use - some included instructions would be helpful or put it in the manual

Just sent this message to support.

The saga goes on Sad

I knew that would happen with your order about the connectors. That is why I held off. They tell you to let them know that you need the ring term connectors but there is no place to do that when ordering that I'm aware of. And that they would install them for you. Does it fit ok in the case?

Can't see how it can with all the wires and being a bit longer as well. But the section is a smaller.
Not bothered as long as it will fire up.

Notice that have recently put this up on the purchase page:
4. If you need the PSU to replace the one in S4/S4+, please kindly mark "need the switch board to use in S4/S4+" in comment field when placing order, we'll add it when shipping out the PSU. Otherwise, it'll not be included.
No instructions on how to wire it up though.

But S5+ available needs 3 of these to power it !!